Transcript: The rotor shaft of an helicopter drives the rotor blades that provide the lifting force to support the helicopter in the air. As a consequence, the shaft is subjected to a combination of torsion and axial loading. For a 50mm diameter shaft transmitting a torque T-2.4kN.m and a tensile force P 125kN, determine the maximum tensile stress maximum compressive stress, and maximum shear stress in the shaft Use CREO to solve it. Verify manually.

 

Transcript: A cube of timber 1.25 ft on each side floats in water as shown below. The specific gravity of the timber is SG = 0.6. Find the submerged depth, D. Find the weight of the floating can in the diagram below.

 Briefly explain why it was necessary to pass the Digital Millennium Copyright Act (DMCA), into law in 1998.

List and explain the two ways from which NFB amplifiers are specified with the aid of block diagram, explain how the input and output ports of the amplifier are utilized.

Bending Strength of Compact Shapes

The beam in Figure P5.5-2 has continuous lateral support. If the live load is twice the dead load, what is the maximum total service load, in kips/ft, that can be supported? A992 steel is used.

a. Use LRFD.
b. Use ASD.

Use the Booth algorithm to multiply -23 (multiplicand) by 29 (multiplier), where each number is represented using 6 bits. Show the procedure in detail.

Convert the following decimal number to IEEE 32-bit floating-point format
i) -16.625 X 10 - 4
ii) -3013.3125

Design a memory module that should have a capacity of 64Mx32 bits using 4Mx4bits ICs and required logic gates/systems.

Draw internal architecture of a 64Megabit DRAM (16M X 4) IC using schematic diagram, identify functional units, and required pins and signals. Briefly explain function of each unit.